Settings; Front Seat Height; Adjusting The Front Seat Height By Using The Front Fork Attachment; Setting The Angle Of The Front Fork Attachment - Etac Transit Manual

The front seat height may be adjusted by:
-Using the front fork attachment, adjustable in height
and angle.
Risk of tipping: Always check the setting of the
the anti-tips.

Adjusting the front seat height by using the front fork attachment

Loosen the screws (A and B). Adjust according to position
marking (C) to obtain equal height on both sides.
Check and adjust the angle of the attachment and tighten
the screws (see section "Setting the angle of the front fork
attachment")
Risk of tipping: Always check the setting of the
the anti-tips.

Setting the angle of the front fork attachment

The correct angle setting is important
for the wheelchair's manoeuvrability.
Unscrew the lower attachment screw (A) about 2 turns so
that the shaft (C) moves freely inside the sleeve.
Insert the Allen key in the hole (B) and turn until the at-
tachment is 90° to the floor. Always start from a position
that enables the wheel to move forward in the rotation (D).
Hold the shaft in place while the lower attachment screw is
tightened.
B
A

5. Settings

Front seat height

6 mm
C
20Nm
C
A
B
Risk of tipping: Always check the setting of the
the anti-tips.
Keep your eye on something vertical, e.g. a door frame or
table leg, while setting the angle.
D
6 mm
20Nm