Adjust Back Support Angle, 3A; Adjust Back Support Height And Lumbar Angle, 3A - Etac Cross 6 Manual

Etac / Cross 6 / www.etac.com
Adjust the back support angle, 3A
The angle of the back support is continuously adjustable
(see "The chair's possibilities").
1. Loosen the nut.
2. Adjust the back angle. Use the bar markings or count the number
of "clicks" to get the same back angle on the right and left sides
respectively. The click positions have 3° intervals and are only
1
13 mm
Adjust the back support height and lumbar angle, 3A
The back height is adjustable (see "The chair's possibilities").
1. Loosen the locking screws (A) max 1 turn.
2. Adjust the back height using the scale and mark on the lower back
rail. Tighten the locking screws max 1/2 turn.
3. Insert the Allen key into the eccentric sleeve locking screw and
loosen this 1/2 turn. Move the Allen key to the eccentric sleeve's
key grip and set the desired lumbar angle.
4. Tighten the locking screws.
1
5 mm
A
12. Advanced settings, customization
2
"Click"
2
for simplifying the setting, the back angle can therefore also be
adjusted between the click positions.
3. Tighten the nut.
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
3
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
3
26
20 Nm
6 Nm