Steelcase FrameOne Manual page 6

®
For Table Open and Closed Loop Legs
1.
For each table leg: Install the plastic covers in the two (2) places,
per leg, as shown.
2.
Place the worksurface flush with the front face of the leg (2a).
Flush the edge of the leg with the side of the worksurface (2b).
Install twenty-eight (28) #10-10 x 1" wood screws per leg (2c).
3.
Table worksurfaces need to be leveled both front to back &
side to side. Perform leveling by adjusting the glides.
NOTE: For worksurfaces with a Personal Caddy, the Personal Caddy
understructure support bracing must be installed before the legs.
Refer to assembly direction 939502139.
2c
FLUSH
2a
1
FLUSH
2b
939500590 Rev F
Page 6 of 8