sauter FC Instruction Manual page 11

6.9.2 Default value outputs
Two preset value outputs form an open collector in the NPN version.
The circuit diagram below shows the inner default value circuit:
Pins 6 and 7 are switched on after the overload alarm is triggered.
In setting mode, pins 6 and 7 are switched on after the upper limit value has been
exceeded, and pins 4 to 6 - after the lower limit value has been fallen below.
Max. permissible voltage: for pins 7 to 6 and 4 to 6 the voltage must be below
35V, and for pins 6 to 7, pins 6 to 4 below 6V!
FC-BA-e-2020 11