Figure 9-2
DIP switch on the upper side of the component
When delivered, "single operation" is set. Both switches are set to the left.
9.4
Connection examples
9.4.1
General information
The Control Supply Module is connected to the line supply via interface X1 (screw terminals 0.2
to 4 mm
Note
Each Control Supply Module is to be connected via a suitable circuit breaker, or alternatively a
safety fuse.
The types specified in the "Technical data" for the respective module are to be used in this regard.
For applications according to IEC, equivalent fuses and circuit breakers are permissible.
High Frequency Drive
System Manual, 10/2020, 6SL3097-5AH10-0BP0
).
2
Control Supply Module (CSM)
9.4 Connection examples
137