Table of Contents
Advertisement
Installation
•
During normal operation, the condenser and compres-
sor at the back of the appliance heat up considerably.
For safety reasons, minimum ventilation must be as
shown in the relevant Figure.
Attention: keep ventilation openings clear of ob-
struction.
•
If the appliance is transported horizontally, it is possible
that the oil contained in the compressor flows in the re-
frigerant circuit. It is advisable to wait at least two hours
before connecting the appliance to allow the oil to flow
back in the compressor.
•
There are working parts in this product which heat up.
Always ensure that there is adequate ventilation as a
failure to do this will result in component failure and
possible food loss. See installation instructions.
•
Parts which heat up should not be exposed. Wherever
possible the back of the product should be against a
wall.
•
If the appliance has been transported horizontally, it is
possible that the oil contained in the compressor ílows
in the refrigerant circuit. It is advisable to wait at least
twoIhoursIbeforeIconnectingItheIapplianceItoIallowIthe
oil to flow back in the compressor.
CONTENTS
Warning
GeneralIsafety
USE
Cleaning the interior
Before using the appliance for the first time, wash the in-
terior and all internal accessories with luke-warm water
and some neutral soap so as to remove the typical smell
of a brand-new product, then dry thoroughly.
Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit
or insulation materials. The appliance shall not be dis-
carded together with the urban refuse and rubbish.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. Information on your local dis-
posal sites may be obtained from municipal authori-
ties. The materials used on this appliance marked by
the symbol
Disposal of old Appliances
The symbol
cates that this product may not be treated as household
waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of cor-
rectly, you will help prevent potential negative conse-
quences for the environment and human health, which
could otherwise be caused by inappropriate waste han-
dling of this product. For more detailed information about
recycling of this product, please contact your local city of-
fice, your household waste disposal service or the shop
where you purchased the product.
36
36
36
36
37
37
Something not working
37
37
37
38
38
38
38
38
After
Sales
38
38
39
39
39
39
39
39
39
Do not use detergents or abrasive powders, as
these will damage the finish.
are recyclable.
on the product or on its packaging indi-
40
40
40
41
41
41
41
42
42
43
43
43
44
37
Advertisement
Chapters
Table of Contents
