Parameter Reference - Siemens SITRANS LG200 Series Instruction Manual

Parameter Reference

The following parameter listing explains the SITRANS LG200 parameter menus. Each
parameter is marked if it applies specific application types (Level, Volume, Interface/
Level, Interface/Volume).
The parameters are in the order they would appear if the arrow keys were used to scroll
through the menu.
To reset SITRANS LG200 to factory defaults, set each parameter to the default parameter
settings shown in user parameters below or listed in
List
on page 72.
Display loop
Run Mode Display Options
*Status*
If you choose *Status*, the LG200 display will show Status, Level , % Output, and Loop
(and/or Volume, and/or Interface/Level, and/or Interface/Volume) values cycling every
two seconds.
Values (View only)
Level: Measures
level only in
selected level
units
Level
Displays level value in selected units.
Values (View only)
7ML19985KA02
*Status*
*Level* or *Volume* or *IfcLvl* or *IfcVol*
*% Out*
*Loop*
Volume: Measures
volume only in
selected volume
units
Level xxx.x (in, cm, ft, m)
SITRANS LG200 – INSTRUCTION MANUAL
Appendix A: Alphabetical Parameter
Interface/Level Interface/Volume
(Ifc/Level): (Ifc/Vol): Measures
Measures interface level and
upper level and interface volume
interface level
Page 57