Table of Contents
Advertisement
Quick Start Programming
1.
Power up the LG200 transmitter. The display changes every 2 seconds to show one
of four values: Status, Level, %Output, and Loop current. See
Options
on page 57 for more information about each display option.
2.
Remove the cover of the electronics.
3.
Use Down (
the next.
4.
Press the Enter (
changes to an exclamation point (!).
5.
Use Up or Down Arrow keys
display or to scroll through the choices.
6.
Press the Enter (
configuration process (the default password is 0).
7.
To return to RUN mode, scroll to the display parameters (*Status*).
8.
After entering the last value, allow 10 seconds before removing power from the
transmitter (save function).
Transmitter Display and Keypad
The SITRANS LG200 transmitter has a liquid crystal display (LCD) capable of showing two
lines of 8 characters each. Transmitter measurements and configuration menu screens
are shown on the LCD.
The transmitter default display is the measurement screen. It cycles every 2 seconds to
display STATUS, LEVEL, *%OUT*, and LOOP information. See
on page 57 for more information about each display option. The transmitter defaults to
this display after 5 minutes if no keystrokes are sensed.
The keypad has three arrows used to scroll through the displays and to calibrate the
transmitter: Up and Down Arrow (
7ML19985KA02
) arrow key to move from one step of the configuration program to
)arrow key. The last character in the first line of the display
to increase or decrease the value in the
) arrow to accept a value and move to the next step of the
SITRANS LG200 – INSTRUCTION MANUAL
earth terminal
enter
down
up
Run Mode Display Options
) keys and the Enter (
Run Mode Display
) key.
Page 43
Advertisement
Table of Contents
