Siemens SITRANS LG200 Series Instruction Manual page 78

Parameter Name
Run Time (factory authorized personnel only)
Safety Zone Alarm Reset (SZ Alarm Reset)
(User password)
Safety Zone Fault (SZ Fault)
Default: None (User password)
Safety Zone Height (SZ Height)
Default: 2.0 in (User password)
Safety Zone Hysteresis (Sz Hyst) (factory authorized personnel only)
Default: 1.0 in (Superuser password)
Scale Offset (Scl Ofst) (factory authorized personnel only)
Default: 0 (Factory password)
Sensitivity (Senstvty)
Default: 55, probe model dependent ((User or Superuser password)
Strapping Table (Breakpoints)
Default: 0.0
Strapping Table (StrapTbl)
Default: Pt Lvl: 0.0 cm, Pt Vol 0.0 g (User password)
Target Calibration (Lvl only) (factory authorized personnel only)1
Default: 1000
Threshold (Threshld)
Default: Fixed (User password)
Trim 20 mA (Trim 20)
Default: 3266 (User password)
Trim 4 mA (Trim 4)
Default: 651 (User password)
Trim Level (Trim Lvl)
Default: 0.0 in (User password)
Dielectric (Dielctrc)
Default: 2.10 (User password)
Window (Window) (factory authorized personnel only)
Default: 204 (Factory password)
Signal (Signal) (factory authorized personnel only)
Target Amplitude (Lvl only) (factory authorized personnel only)1
Target Ticks (Lvl only) (factory authorized personnel only)1
Page 74 SITRANS LG200 – INSTRUCTION MANUAL
Page Number
69
67
66
66
71
70
64
62
62
70
67
67
67
67
63
69
70
70
70
7ML19985KA02