Table of Contents
Advertisement
2
Safety Instructions
WARNING
Serious injuries or even death possible!
Disconnect screwdriver from air/power supply when adjusting the clutch or
changing/mounting the screwdriver tool (bit, socket) or accessory.
CAUTION
Risk of injury to persons or damage to the tool/work piece.
Avoid pressure to fall below the minimum allowable air pressure, because
the clutch cannot shut-off safely anymore.
CAUTION
Fingers may be crushed by the rotating clutch in the adjustment slot.
Keep fingers away from the clutch adjustment slot.
CAUTION
Risk of crushing hands between holding bracket and work piece or
modification parts in confined spaces.
Make sure that any bracket used is correctly installed.
Keep hands away from holding fixture (if used). This applies especially
when unscrewing.
CAUTION
Rotating drive, rotating bit/socket or drive extension.
Injuries to fingers or even broken fingers.
When wearing gloves (e.g. rubber coated or metal reinforced) make sure
that they not become entangled.
Do not wear loose fitting gloves or gloves with cut or frayed fingers.
• Never hold the drive, screwdriver tool or drive extension with your hands.
• If you cannot support the reaction torque of the machine independently then use a
torque support (e.g. linear stand, telescopic arm, holding fixture/holder-on, support grip).
It generally applies that: In any case use a torque support to absorb the reaction
torque above: for straight screwdrivers 4 Nm; for pistol grip screwdrivers 10 Nm and for
angle nutrunners 60 Nm.
• If it is not possible to use a torque support, use side handles for straight and pistol grip
screwdrivers. Side handles are recommended for straight screwdrivers at a torque set-
ting over 4 Nm and for pistol grip screwdrivers at torque settings over 10 Nm.
• Use a finder/sleeve fitting where practicable.
• When using sockets or adapters (e.g. magnet holder) make sure that they are in good
condition and suitable for use with this machine.
• To prevent sockets breakage use only sockets (e.g. for impact or impulse screwdrivers)
which are suitable for use with this machine.
4
Advertisement
Table of Contents
