Names And Functions - FujiFilm UA107x8.4BESM-T35K Operating Manual

Note. The encircled numbers indicate the numbers in the outline drawing (Fig. 1).
① Tally Lights (2 places)
② Handles (2 places)
To carry this lens, hold these handles with both hands.
③ Shroud Attaching Knobs (2 places)
The knobs to fix the lens shroud to the body of the lens.
④ Extender Remote/Manual Select Switch
To select the extender manually, set this switch to "MANU."
To select the extender by means of a remote control unit such as a range selector, set this switch to "REMO."
⑤ Extender Select Knob
The extender manual selection is performed by means of this knob.
⑥ Zoom, Iris, Extender Indicator
This indicator shows the present positions of the zoom, iris and extender.
⑦ Indicator ON/OFF Select Switch
Operation of this switch can select ON or OFF of "Zoom, Iris, Extender Indicator."
⑧ Hood
This hood prevents the extra light from entering the lens.
⑨ Servo Modules (2 places)
To control the lens with servo control units, install servo modules.
⑩ Manual Module (2 places)
To control the lens with manual control units, install manual modules.
⑪ RS-232C Connector ( DE-9PF-N, JAE )
In either self-diagnosis operation using a Fujinon Find System or remote-control operation using a computer, the
communication with a computer can be made through this connector.
The RS-232C connecter is located inside the lens.
When it is required to control the lens using a personal computer, detach the partial cover under the connector.
The cover can be detached by removing the four screws that attach the cover.
(For the lens control protocol, contact the sales agent from which you purchased the lens.)
⑫ Connector for Macro Control
This connector is provided for a macro control unit.
⑬ Connector for Encoder Output (HR25-9R-20S, HIROSE)
The connector for outputting digital signals derived from the
iris, focus, and zoom encoders.
For the output signal, refer to section "Specifications of
Encoder Output Signal" on page 16.
⑭ Connector to Range Selector ( HR10G-10R-12S, HIROSE )
This connector is provided for either a range selector or an iris
control unit.
⑮ Connector for Stabilizer Control
This connector is provided for an optical stabilizer control unit with which the camera operator can select the optical
stabilizer function of the lens. (To select the optical stabilizer function using an optical stabilizer control unit, set the
stabilizer H+V/OFF/V select switch of the lens to OFF.)
４. NAMES AND FUNCTIONS
( HR25-9R-20S, HIROSE )
( R03-R8F3, TAJIMI )
- 3 -
⑫ Connector for
Macro Control
⑮ Connector for
Stabilizer Control
⑭ Connector for
Range Selector
⑬ Connector for Encoder Output