Selection Of Camera - FujiFilm UA107x8.4BESM-T35K Operating Manual

PRIOR TO USE

(4) Selection of Camera

The behavior of the intercom select switch in an accessory differs by types of camera. If required, change the setting
of dip switch (S710-7) on the A-board in the lens according to the type of camera.
At the factory, the switch is set to "TYPE 1."
The circuits relative to the dip switch are shown below.
Ⅰ . TYPE 1 CAMERA : BVP-270 series (NTSC) and BVP-370 series (NTSC)
INCOM 1 SW
INCOM 2 SW
CAMERA
Ⅱ . TYPE 2 CAMERA : BVP-370 series (PAL)
INCOM SETTING LINE
INCOM (1) SW
CAMERA
Note. If the camera is of TYPE 2, set the intercom select switch on the camera side to "PD."
At the position of "ENG,"
A-BOARD
LENS
LENS
"PD" can not be selected from a zoom rate demand unit.
A-BOARD
S710
- v -
ENG
PD
ACCESSORY
( Ex. ERD-5A-D01/ERD-5A-D11 )
ENG
PD
ACCESSORY
( Ex. ERD-5A-D01/ERD-5A-D11 )
Setting of Dip Switch (S710-7)
OFF: Camera Type 1
ON: Camera Type 2