Prior To Use; Before Installing Onto Camera; Caution When Using The Lens Supporter; Enclosure Of Desiccant - FujiFilm UA107x8.4BESM-T35K Operating Manual

(1) Before Installing onto Camera

When it is required to install this lens on a Sony studio camera (Ex. HDC-4300) or on a Sony large lens adapter (Ex.
HDLA-1500), remove the pin on the bayonet mount of the lens, and attach it to the threaded hole in the mount frame.
To install this lens on another camera, reinstall the pin on its former position.

(2) Caution when using the lens supporter

When using this lens with a Fujinon lens supporter (ELH-*) attached, use a power source connecter (see "Name and
Function of Each Part") to supply power from the lens side. If power is not supplied, correct operation may not occur.

(3) Enclosure of Desiccant

The inside of this lens is able to enclose desiccant in order to eliminate humidity that may mist the surfaces of the
internal glasses. A desiccant bag for storage was enclosed in the desiccant enclosure place before shipment at the
factory. Prior to use, take out this bag first, and put new desiccant bags in that place as follows:
a. There are twelve desiccant bags in the trunk. Take out two of them to use. The rest should be used when the
exchange of the desiccant is required.
b. Loosen the two lens shroud attaching knobs on the both sides of the lens. Draw the shroud towards the front of the
lens to detach it from the body.
c. Remove the four screws to take off the lid.
d. Take out the desiccant bag for storage.
e. Fold new desiccant bag and put it in the desiccant enclosure place.
f. Put the detached lid in its place and reinstall the four screws. Finally, reinstall the lens shroud.
Note 1. Perform the above procedure in a dust-free place.
Note 2. In a humid region, it is recommended to change the desiccant bags two times a year. The desiccant being
jellied indicates the time when it must be exchanged.
DESICCANT ENCLOSURE PLACE

PRIOR TO USE

THREADED HOLE
DESICCANT BAG
FOR STORAGE
- iv -
PIN
NEW DESICCANT BAG