JLG 800A Service And Maintenance Manual page 85

18. Cover shaft splines with an installation sleeve. Install a
new shaft seal (27) with the cup side facing the motor.
Press seal into housing until it bottoms out. Press evenly
to avoid binding and damaging the seal. Install seal sup-
port washer (28) and snap ring (29).
29
28
27
27. Shaft Seal
28. Seal Support Washer
29. Snap Ring
Figure 3-27. Shaft Seal
3121628
SECTION 3 - CHASSIS & TURNTABLE
19. Install remaining plugs and fittings to the housing. Refer
to the drawing below for wrench sizes and installation
torques.
5/16 in
63 ft.lbs.
(85 Nm)
5/16in
63 ft.lbs.
(85 Nm)
Figure 3-28. Plugs and Fittings Installation
1/4 in
33 ft.lbs.
(45 Nm)
9/16 in
125 ft.lbs.
(170 Nm)
3 mm
1.5 to 2.5 ft.lbs.
(2.03 to 3.39 Nm)
1/4 in
33 ft.lbs.
(45 Nm)
3-31