JLG 800A Service And Maintenance Manual page 68

SECTION 3 - CHASSIS & TURNTABLE
23. Install thrust washers and thrust bearing (39, 40) into
carrier counterbore.
24. Place o-ring (22) into cover assembly counterbore. Use
petroleum jelly or grease to hold o-ring in place.
25. Place cover assembly over ring gear with oil level check
plug in cover located approximately 90 degrees from oil
fill plug in hub.
26. Locate four bolts (42), 90 degrees apart into counter-
bored holes in hub marked in step (16). Torque bolts to
47 ft. lbs. (64 Nm).
3-14
27. Install bolts (41) in remaining holes. Torque bolts to
47 ft. lbs. (64 Nm).
28. Place coupling (1) into spindle and onto input shaft.
29. Fill hub one-half full of EPGL 90 lubricant before
operation.
3121628