JLG 800A Service And Maintenance Manual page 66

SECTION 3 - CHASSIS & TURNTABLE
11. Install thrust washers and thrust bearing (39, 40) on the
portion of the spindle which extends into the internal
gear.
12. The o-ring is placed into the counterbore provided in
the hub. Slight stretching may be necessary. Use suffi-
cient grease or petroleum jelly to hold in place.
13. Install retaining ring (34) into input shaft retaining ring
groove.
3-12
14. Place input shaft assembly (35) into spindle bore with
unsplined end facing out.
The action of the spring should be checked at this point.
15. Place thrust spacer (36) over input shaft (35) with coun-
terbore side facing spindle.
16. Locate the four counter reamed holes in the face of the
hub, mark them for later identification.
3121628