JLG 800A Service And Maintenance Manual page 65

5. Place bearing cone (6) over end of spindle and into
bearing cup.
6. Place bearing shim (8) over end of spindle and against
bearing cone.
EYE PROTECTION SHOULD BE WORN DURING RETAINING RING INSTALLATION.
7. Install retaining ring (9) completely into spindle groove
and against bearing shim. Ensure retaining ring is
entirely in groove.
3121628
SECTION 3 - CHASSIS & TURNTABLE
8. The disengage spacer and spring are installed into the
counterbore of the spindle.
9. Install retaining ring into input shaft groove to secure
spacers and spring to shaft.
10. Place the internal gear (12) onto end of spindle by
matching the bore spline, the spindle spline.
3-11