JLG 800A Service And Maintenance Manual page 83

8. Press front shaft bearing (15) onto shaft (16). Press bear-
ing onto shaft with lettering facing out. Lubricate bear-
ing rollers. Install snap-ring (17) onto shaft.
16
15. Front Shaft Bearing
16. Shaft
17. Snap Ring
18. Snap Ring
Figure 3-22. Shaft and Front Bearing
9. While holding the swashplate in place, turn the housing
on its side. Install the install shaft/bearing assembly into
housing from the flange end. Install the snap-ring (18).
3121628
15
17
18
SECTION 3 - CHASSIS & TURNTABLE
10. Verify swashplate and bearings are properly seated.
Install the cylinder kit (19) onto the shaft. Install with the
slippers facing the swashplate. Rock the shaft to align
the block splines and slide the cylinder kit into place.
Orient the motor with the shaft pointing downward and
verify the cylinder kit, swashplate, journal bearings, and
servo piston are all secure and properly installed.
19
19. Cylinder Kit
Figure 3-23. Cylinder Kit Installation
11. Lubricate and install the servo spring (20), and minimum
angle stop (21) into the housing bore.
20. Servo Spring
21. Minimum Angle Stop
Figure 3-24. Servo Spring and Minimum Angle
Stop
21
20
3-29