Ingenico iWL250B Manual page 7

Hardware Connections – Serial to USB Adapter
The iWL250B PIN pad is certified to work with the Cables to Go Serial to USB cable adapter Model: 26886. To download
the driver for the adapter click here. Extract all of the files from the PL2303_Prolific_DriverInstaller_v1_8_0.zip folder
and run the PL2303_Prolific_DriverInstaller_v1_8_0.exe file as administrator to install the driver for the adapter. After
the adapter driver has been installed, you'll need to confirm the Serial connection settings on the PIN pad and configure
the adapter port settings in the Windows Device Manager.
1. Locate the included RJ 11 to serial
cable. It is labeled with part #
CABxxxxx. Identify End 1 and End 2
2. On the bottom of the PIN pad dock,
locate the panel clips and pull back
on both clips at the same time to
loosen the panel and pull it off of
the dock.
3. Connect End 1 in the RJ 11 port
labeled COM1.
4. Run the through the space by the
dock ports.
5. Place the cover back on the dock.
6. Connect End 2 of the RJ11 to serial
cable to End 2 of the USB to Serial
adapter.
7 | P a g e