Advertisement
Step 3
Separate the LOCKING EXTENSION SLIDES (Z) from the LOCKING EXTENSION RAILS (Y) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten the LOCKING EXTENSION RAILS (Y) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Fasten the CABINET RIGHT (35AW) to the RIGHT END (A) and the CABINET LEFT (35AX) to the LEFT END (B). Use four
å
GOLD 5/16" FLAT HEAD SCREWS (3S) through the fi rst and second holes from the roller end in the RAIL and into the
holes of your choice in the ENDS.
Now, insert the CORD CLIP (4P) into the hole in the RIGHT END (A). The CORD CLIP is used to hold your ELECTRICAL
å
OUTLET cord in place.
Finished edge
Open end
Page 8
Y
B
Roller end
Z
Push the silver tab in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
A
Y
Open end
Y
Roller end
Finished edge
4P
Advertisement
