Related Manuals for Teknik City Center 5425658
Summary of Contents for Teknik City Center 5425658
- Page 1 Teknik www.teknikoffice.co.uk The stories of your life. Tall Bookcase NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. City Center Collection | Model 5425658 PLEASE READ AND KEEP FOR FUTURE REFERENCE.
- Page 2 Table of Contents Assembly Tools Required Part Identification No. 2 Phillips Screwdriver Tip Shown Actual Size Hardware Identification Assembly Steps Hammer Not actual size Safety Electric drill with 1/8" or 3/8" bit (ONLY in indicated step) Page 2...
-
Page 3: Part Identification
Now you know Part Identification our ABCs. å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge to help distinguish similar parts from each other. Use this part identification to help identify similar parts. LEG (4) TOP (1) SHELF WITH INSERT (2) -
Page 4: Hardware Identification
Hardware Identification å Screws are shown actual size. You may receive extra hardware with your unit. FURNITURE TIPPING L-WRENCH - 1 RESTRAINT KIT - 1 13/16" HEX HEAD SCREW - 24 1/2" PAN HEAD SCREW - 16 Page 4... - Page 5 Step 1 å Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor. å Fasten the LEGS (A) to the TOP (B). Tighten eight 13/16" HEX HEAD SCREWS (2) using the L-WRENCH (1). å...
- Page 6 Step 2 å Fasten the SHELVES (D) to the TABS on the LEGS (A). Use sixteen 1/2" PAN HEAD SCREWS (3). å NOTE: You should start each SCREW a few turns to help line up the holes. å Completely tighten all of the SCREWS in your unit. 1/2"...
- Page 7 Step 3 å Carefully stand your unit upright against the wall in its final location. å - Use the FURNITURE TIPPING RESTRAINT KIT (96) for added stability. Fasten the SAFETY STRAP to the TOP (B) using the short screw. å The following instructions show your unit being fastened to a wall stud.
- Page 8 Step 4 å - With your pencil, strike a mark through the center of the hole in the SAFETY STRAP. å - Drill a 3/8" hole on the mark. å - While you squeeze the wings together, gently tap the WALL ANCHOR from the FURNITURE TIPPING RESTRAINT KIT (96) into the hole until it is even with the surface of the wall.
- Page 9 WARNING Please use your furniture correctly and safely. Improper use can cause safety hazards, or damage to your furniture or household items. Carefully read the following chart. Look out for: What can happen: How to avoid the problem: • Overloaded shelves. •...