Advertisement
Step 8
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (40MA) to the OUTER UPRIGHTS (L). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the UPRIGHTS. Turn a SCREW into
this hole.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
Edge with
TWIST-LOCK®
FASTENERS
3S
(4 used in this step)
L
40MA
L
Open end
Open end
Edge with
TWIST-LOCK®
FASTENERS
Page 13
Advertisement
