Configuration Of Technostring - IBA ibaFOB-TDCexp Manual

ibaFOB-TDCexp
7.2.4

Configuration of Technostring

If the card has been installed correctly the interface TDC should be available under Tech-
nostring.
After adding the module Technostring you can enter the data that are needed for the
Technostring reception and the data processing.
After entry of the standard parameters the following settings must be defined:
 Entry of terminator character according to the Technostring definition in chapter
7.1.3 "Technostring", default is 13 ('CR').
 Selection of board type ibaFOB-TDC or ibaFOB-TDCexp.
Figure 13:
Other documentation
For more detailed description of the Technostring configuration, please refer to the
general ibaPDA manual.
ConfigurationTechnostring
Manual
Issue 1.2
25