Table of Contents
Advertisement
RC4600 ACU Board Set
Chapter 2
Hardware
2.1.2.2.3.5 User Interface Firmware
The User Interface Firmware window allows the user to update the current user interface software on the
RC4600.
NOTE: Updating the user interface firmware may cause the IP settings of the RC4600 to be reset to
factory defaults. The default IP address of the RC4600 is 192.168.1.1.
After clicking the <Start Update> button, the window will change to show the status of the software
update. Once the software is fully transferred and installed, the <Done> button will change from grayed
out to active. Clicking the <Done> button will return the user to the main configuration page.
74
Advertisement
Table of Contents
