Table of Contents
Advertisement
RC4600 ACU Board Set
2.1.2.1.6
Signal Strength and Transmit Status
Chapter 2
On the right side of the main display are two bars for signal
strength, and two icons that indicate transmit and locate status.
The left signal strength value will always display signal strength
coming from the L-Band power detector. In addition to the
graphical representation, the numeric value of the signal strength is
displayed at the bottom.
The right signal strength value is the current signal strength source
being used by the RC4600 for tracking, locates, and peaking.
It can be toggled between, BCN (Beacon Receiver), RF (L-Band
Power), DVB (DVB Receiver), and EXT (External AGC). If the
signal strength source being used supports a lock input, the green
"LOCKED" box will show at the bottom of the graphical signal
strength when the receiver is locked.
The indicator shown below indicates that the antenna is in a state
where it is OK to transmit. When moving or below the down limit,
the indicator will be grayed out.
The indicator shown below indicates that the previous LOCATE
finished successfully. This indicator will stay green until the
RC4600 is powered off, or a new LOCATE is started. The indicator
will be grayed out at the end of a LOCATE if it was unsuccessful.
63
Hardware
Advertisement
Table of Contents
