Table of Contents
Advertisement
RC4600 ACU Board Set
2.1.1.2.2
MENU Mode
MENU mode allows the user to select one of listed modes. Pressing the Mode key will move to MANUAL
mode.
1 - D E P L O Y
4 - T R A C K
7 - P O S I T I O N 8 - M O V E T O
< 0 - 9 > S E L E C T < M O D E > M A N U A L
MENU mode displays the time and time zone in the lower right-hand corner.
2.1.1.2.2.1 DEPLOY
The DEPLOY mode automatically moves to the mount's predefined "deploy" position. See Appendix B
for the list of deploy positions for the various mounts supported. The deploy command requires an
explicit confirmation in order to initiate antenna movement.
< M O D E > M E N U ( D O N O T D E P L O Y )
< B K S P > C O N T I N U E D E P L O Y
Pressing the <BKSP> key will initiate the DEPLOY movement. If the DEPLOY mode was inadvertently
entered, pressing the Mode key will return to the MENU mode without initiating antenna movement.
a z :
e l :
M O V I N G A N T E N N A T O D E P L O Y
As each axis moves, its label (az/el/pl) will flash and the current position will update. The target deploy
positions will be displayed in parenthesis. The sequence of axis movement will be mount dependent.
Following completion of movement to the deploy position, the RC4600 will return to MANUAL mode. The
automatic movement may be terminated anytime by pressing the <Stop> key.
Chapter 1
2 - S T O W
0 . 0 0 0
(
0 . 0 )
1 3 . 2 3 6
(
1 6 . 0 )
3 - L O C A T E
0 - P E A K U P
9 - S T A N D B Y
0 0 : 0 4 : 3 1
< S T O P > H A L T
27
Introduction
M E N U
U T C
D E P L O Y
D E P L O Y
Advertisement
Table of Contents
