Table of Contents
Advertisement
RC4600 ACU Board Set
2.1.2.1.4.2.4 Marker Controls
2.1.2.1.4.3 Tracking Diagnostic
When in the TRACK mode, the tracking diagnostic tab shows information about the current pointing
position, track table points, and the last 2 minutes and 30 seconds of signal strength data.
In the image above, the left box shows the current pointing angles in azimuth and elevation (yellow dot),
and the track table points (red dots) and the path that the RC4600 will take between points.
The box on the right shows a graphical representation of the last 2 minutes and 30 seconds of signal
strength.
The range on the vertical axis for both boxes, and the horizontal axis for the left box will adjust as needed
to accommodate the data that is being displayed.
Chapter 1
The Marker controls allows the position of the marker on the
spectrum to be controlled. The Marker is designated by a red mark
with a dotted line running to the vertical scale on the right. The
Marker Level is displayed to the left of the red mark on each sweep.
The Marker Frequency is displayed in the Freq. window. The
Marker Frequency can be set by direct entry or using the + -
buttons to increment by 1/5th of a frequency division. The Find
Peak Button positions the Marker on the highest level visible on the
current sweep. The Marker -> CF changes the Center Frequency
of the span to that of the Current Marker.
55
Introduction
Advertisement
Table of Contents
