Table of Contents
Advertisement
RC4600 ACU Board Set
<3>GET LOCATION FROM GPS
G P S : 3 8 _ 5 7 N 9 4 _ 4 5 W
U T C : 2 1 : 4 2 : 0 0
When option 3 is selected, the RC4600 will pull in the lat/lon from the GPS. Once complete the controller
will automatically move back to the main POSITION screen. Note that if movement is required to acquire
the GPS information, the following screen will be displayed so the user can confirm the movement.
< E N T E R > C O N F I R M M O V E
2.1.1.2.2.5.2 HEADING
When the user chooses to modify latitude and longitude, a screen appears showing three options for
updating the current lat/lon.
< 1 > E N T E R M A G N E T I C H E A D I N G
< 2 > E N T E R T R U E H E A D I N G
< 3 > G E T H E A D I N G F R O M C O M P A S S
<1>ENTER MAGNETIC HEADING
M A G V A R :
< 0 - 9 . > E N T E R D E G R E E S
When option 1 is selected, the user is prompted to ender a magnetic heading of the antenna. After
magnetic heading is entered, the RC4600 will apply the magnetic variation to generate the true heading
of the mount's azimuth centerline.
<2>ENTER TRUE HEADING
M A G V A R :
< 0 - 9 . > E N T E R D E G R E E S
When option 2 is selected, the user is prompted to ender a true heading of the antenna. After true
heading is entered, the RC4600 will apply the magnetic variation to generate the magnetic heading of the
mount's azimuth centerline.
*
A N T E N N A M O V E M E N T R E Q U I R E D
*
T O D E T E R M I N E L O C A T I O N
M A G :
1 . 7
T R U E :
M A G :
1 . 7
T R U E :
Chapter 1
< M O D E > E X I T
< M O D E > E X I T
< M O D E > E X I T
< S C R U P > E X I T
< S C R U P > E X I T
43
Introduction
L A T / L O N
L A T / L O N
*
*
H E A D I N G
H E A D I N G
H E A D I N G
Advertisement
Table of Contents
