Table of Contents
Advertisement
RC4600 ACU Board Set
2.1.2.1.5.4 Track
2.1.2.1.5.4.1 Start Track
If the satellite currently being selected for tracking has not been tracked before, the user will be prompted
with the following screen.
Clicking <YES> will perform a Peak Up (2.1.1.2.2.3.4) using the track source and then begin the track, or
immediately start a TLE track.
Clicking <NO> will return the user to the main page.
Chapter 1
The <Track> button allows the user to enter the
TRACK mode (2.1.1.2.2.4). After clicking the
<Track> button, the user is presented with a list
of preset satellites. The list of satellites is the
set of satellites from the database that have the
same band as the current feed. Selecting one of
the satellites in the list will begin an automatic
locate will then present the user with one of the
options listed in the next few sub sections.
Clicking the <Immediate> button will start a track
in the current position, using the currently
selected signal source.
58
Introduction
Advertisement
Table of Contents
