Table of Contents
Advertisement
RC4600 ACU Board Set
<3>GET HEADING FROM COMPASS
C M P H D G : 1 7 6 . 9
O F F S E T :
M A G V A R :
H E A D I N G : 1 7 8 . 6
When option 3 is selected, the RC4600 will pull in the heading from the compass. After the compass
heading has been pulled in, the RC4600 will apply the offset and the magnetic variation to generate the
heading of the mount's azimuth centerline. Once complete the controller will automatically move back to
the main POSITION screen. Note that if movement is required to acquire the compass information, the
following screen will be displayed so the user can confirm the movement.
< E N T E R > C O N F I R M M O V E
2.1.1.2.2.5.3 TILT
P I T C H :
R O L L :
When option 3 is selected, the RC4600 will pull in the tilt from the dual axis inclinometer. Once complete
the controller will automatically move back to the main POSITION screen. Note that if movement is
required to acquire the pitch and roll information, the following screen will be displayed so the user can
confirm the movement.
< E N T E R > C O N F I R M M O V E
Chapter 1
0 . 0
1 . 7
*
A N T E N N A M O V E M E N T R E Q U I R E D
*
T O D E T E R M I N E H E A D I N G
0 . 5 1
0 . 3 7
*
A N T E N N A M O V E M E N T R E Q U I R E D
*
T O D E T E R M I N E P I T C H / R O L L
H E A D I N G
< M O D E > E X I T
H E A D I N G
< M O D E > E X I T
P O S I T I O N
P O S I T I O N
< M O D E > E X I T
44
Introduction
*
*
*
*
Advertisement
Table of Contents
