Let's Flame - Magicfx FLAMEBLAZER User And Installation Manual

3.7

LET'S FLAME!

CAUTION
1
If DMX is used, follow the next steps:
1. Power the machine.
2. Make sure that the prescribed safety zone is clear and there is a suitable
clearance above the unit for the chosen nozzle.
3. Ensure the e-stop is released, the reset button is not illuminated and move
the MAGICFX® FX-ARM CONTROLLER key into the on position. The FX LED
indicator on both the MAGICFX® FX-ARM CONTROLLER and MAGICFX
FLAMEBLAZER® lights up continuously. In Pyro Control Mode the FX LED
indicator on the machine will flash immediately.
4. Activate the DMX enable address. The FX LED indicator on the machine will
flash.
5. When it's time to flame, set the DMX value for Effect trigger between 200
and 255.
6. Enjoy the view!
7. Set the DMX value for Effect trigger between 0 and 199 if you want to stop
flaming.
8. Always disarm when done firing. This also includes disabling the DMX
enable signal.
NOTICE
NOTICE
32 MAGICFX FLAMEBLAZER
Wind can influence the effect and cause flames and fuel to divert
off vertical.
The maximum continuous duration of the effect is 5 seconds. After
this period the effect will stop automatically. To start the effect
again you must disable and re-enable the Effect trigger.
Directly after moving the MAGICFX
the ON position the pump will activate.
— User and Installation Manual
®
FX-ARM CONTROLLER key to
®