Magicfx FLAMEBLAZER User And Installation Manual page 16

WARNING
WARNING
WARNING
WARNING
16 MAGICFX FLAMEBLAZER
Make sure there are no substances or gasses present that can be
ignited by the emitted flame and fuel from the MAGICFX
FLAMEBLAZER .
®
Using a damaged or an improper installed machine can lead to
death, serious injury or property damage. Always inspect the
machine thoroughly before operation.
Stop operating the machine immediately if emitted fuel catches
fire on the unit or in the burn chamber. Extinguish any burning
fuels with Carbon Dioxide, sand or foam. Consult the safety data
sheet from the supplier for detailed safety instructions.
Always create a suitable safety zone around the effect of the
MAGICFX FLAMEBLAZER
additional 50 % from the maximum height range of the installed
e.g. S nozzle has a height range of up to 6 m so needs 9 m
clearance above (6 m + 50 %). The advised safety zones depend
on the size of the nozzle as each produces a different size flame
as follows:
• S nozzle = 2 m;
• M nozzle = 2.5 m;
• L nozzle = 3 m.
Note that the zone direction shifts accordingly when the machine
is installed in a tilted position.
Note that the zone shifts and increases with wind. As an
approximate guide the distance measurement from the wind
speed (in m/s) should be added to the standard safety zone e.g.
wind speed of 5 m/s can add 5 m to the typical 3 m resulting in
an 8 m safety zone in the direction of wind.
— User and Installation Manual
®
. Furthermore, keep a clearance of an
®