Setup Multiple Machines In A Sequence With Dmx - Magicfx FLAMEBLAZER User And Installation Manual

3.6

SETUP MULTIPLE MACHINES IN A SEQUENCE WITH DMX

CAUTION
NOTICE
DMX IN DMX OUT
POWER IN POWER OUT
RJ45 IN
RJ45 OUT
Optionally connect another machine to the power output with a power link cable. If
DMX is used, follow the next steps:
1. Connect a power link cable between the power output and the power input
of the next machine.
2. Connect an arm cable between the arm out connector and the arm in
connector of the next machine.
3. Connect a DMX cable between the DMX output and the DMX input of the
next machine.
4. Use the buttons or a RDM controller to assign DMX addresses, see Chapter 1.
5. Repeat step 1 to 4 for each subsequent machine.
Do not connect more units to a single electrical circuit than the
installed fuse is able to handle. (Calculate the summed load with
the electrical data from Chapter 1)
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
5-pole male
PowerCon TRUE1 male
RJ45
MAGICFX FLAMEBLAZER
5-pole female
DMX
PowerCon TRUE1 female
POWER
RJ45
ARM
— User and Installation Manual
®
DMX IN DMX OUT
POWER IN POWER OUT
RJ45 IN RJ45 OUT
31