Magicfx FLAMEBLAZER User And Installation Manual page 33

2
If pyro is used, follow the next steps:
1. Power the machine.
2. Make sure that the prescribed safety zone is clear and there is a suitable
clearance above the unit for the chosen nozzle.
3. Ensure the e-stop is released, the reset button is not illuminated and move
the MAGICFX® FX-ARM CONTROLLER key into the on position. The FX LED
indicator on the MAGICFX® FX-ARM CONTROLLER lights up continuously and
the FX LED indicator on the machine flashes immediately.
4. When it's time to flame, turn on a 9-40 Vdc signal from the pyro controller to
the pyro input.
5. Enjoy the view!
6. Turn off the 9-40 Vdc signal from the pyro controller if you want to stop
flaming.
7. Always disarm when done firing.
NOTICE
NOTICE
The maximum continuous duration of the effect is 5 seconds. After
this period the effect will stop automatically. To start the effect
again you must disable and re-enable the 9-40 Vdc.
Directly after moving the MAGICFX
the ON position the pump will activate.
MAGICFX FLAMEBLAZER
FX-ARM CONTROLLER key to
®
— User and Installation Manual
®
33