Programming The Unit; Programming Via Rs232 Serial Port; 400 Power Pulse - 500 Power Pulse: Rs232 Connector; Wf-104: Rs232 Connector - Weco Power Pulse 400 Software Update Manual

2

PROGRAMMING THE UNIT

Before starting the programming procedure disconnect the welding cables from all the unit's welding sockets.
Failure to comply with this instruction can result in serious damage to the programming controller.
1. Set the welding power source ON/OFF switch to "O" to switch the unit off.
2. Use the RS232-RS232 communication cable to connect the USB/RS232 adapter to the unit's RS232 serial port.
If the unit is not equipped with an external RS232 connector for software updates the connection can be made directly to the internal circuit
See § 2.2 PROGRAMMING VIA CONNECTOR DIRECTLY ON THE CIRCUIT BOARDS
2.1

PROGRAMMING VIA RS232 SERIAL PORT

Depending on the type of unit make a connection between the PC and programming connector as described below.
2.1.1 400 POWER PULSE – 500 POWER PULSE: RS232 CONNECTOR
2.1.2

WF-104: RS232 CONNECTOR

COM2: Programming connector for the motor circuit board.
(For programming with the following software: WF104_COM2_..._.mhx)
WARNING!
INFORMATION
boards to perform the programming procedure.
COM1: Programming connector for the process circuit board.
(For programming with the following software: 500_PULSATO_COM1_..._.mhx)
Cod.006.0001.1700
02/09/2016 v1.1
ENGLISH
9/18