Extreme Networks ExtremeSwitching SLX 9140 Hardware Installation Manual page 45

FIGURE 25 Attaching the rear brackets to the extensions at the front of the device
1 Rear brackets, short
FIGURE 26 Attaching the short or long rear brackets to the extensions
1 Rear bracket, short or long
Attaching the rear brackets to the front rack posts
Complete the following steps to attach the rear brackets to the front rack posts.
1. Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts, as shown in
Figure 27. Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the upper and
lower holes in the bracket.
3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
ExtremeSwitching SLX 9140 Hardware Installation Guide
9036857-00 Rev AA
Installing the Universal Four-Post Rack Kit (XBR-R000296)
2 Screws, 6-32 x 1/4-in., panhead Phillips
2 Screws, 6-32 x 1/4-in., panhead Phillips
35