Extreme Networks ExtremeSwitching SLX 9140 Hardware Installation Manual page 32

Installing the Universal Two-Post Rack Kit (XBR-R000294)
FIGURE 12 Attaching the front brackets
1 Top of the device
2 Front brackets
Attaching the front brackets to the rack posts
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack
rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. screws and two retainer nuts as shown in
Figure 13.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. screws and two retainer nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
22
3 Screws, 8-32 x 5/16-in., flathead Phillips
(Figure 13), providing temporary support under the switch until the rack kit is fully secured to the
ExtremeSwitching SLX 9140 Hardware Installation Guide
9036857-00 Rev AA