Extreme Networks ExtremeSwitching SLX 9140 Hardware Installation Manual page 34

Installing the Universal Two-Post Rack Kit (XBR-R000294)
FIGURE 14 Attaching the rear brackets to a rack
1 Retainer nuts, 10-32
2 Rear brackets
Attaching the rear brackets to the switch
Complete the following steps to attach the rear brackets to the switch.
1. Align the right rear bracket to the right rear of the switch and using four 8-32 x 5/16-in. panhead screws, attach the bracket to
the switch as shown in
2. Align the left rear bracket to the left rear of the switch and using four 8-32 x 5/16-in. panhead screws, attach the bracket to the
switch. Again, use the upper and lower slots in the bracket.
3. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb. (17 cm-kg).
24
3 Screws, 10-32 x 5/8-in., panhead Phillips
Figure 15. Be sure to insert the screws through the upper and lower slots in the bracket.
ExtremeSwitching SLX 9140 Hardware Installation Guide
9036857-00 Rev AA