Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Uprights (B) to Lower Crossmember (A) using:
4 - (#1) M12x80mm Hex Head Bolt
8 - (#5) M12 Flat Washer
4 - (#8) M12 Nylon Lock Nut
2 - (H) Bracket
1B. Attach Uprights (B) to Upper Crossmember (C) using:
4 - (#1) M12x80mm Hex Head Bolt
8 - (#5) M12 Flat Washer
4 - (#8) M12 Nylon Lock Nut
2 - (H) Bracket
11
Advertisement
