Advertisement
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP 4D. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.
4A. Attach Back Pad (#12) to Back Pad Frame (E) using:
6 - (#3) M8x25mm Hex Head Bolt
6 - (#6) M8 Flat Washer
6 - (#7) M8 Lock Washer
4B. Attach Seat Pad (#10) to Seat Frame (M) using:
4 - (#3) M8x25mm Hex Head Bolt
4 - (#6) M8 Flat Washer
4 - (#7) M8 Lock Washer
4C. Insert Seat Frame (M) into Center Frame (D).
4D. Screw Pop Pin (#11) into Center Frame (D).
17
Advertisement
