Table of Contents
Advertisement
Simrad EK80 Harbour Acceptance Test
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• All relevant vessel drawings, installation reports and/or measurement results are
available.
• The EK80 system is turned on and operates normally.
• The vessel is berthed.
Neither tools nor instruments are required. For connections and communication
parameters, see the relevant end-user documentation from the sensor manufacturer.
Context
In most cases a suitable sensor is already installed on the vessel. A global positioning
system (GPS) with a compatible output format can also be used.
The properties of each of the available communication ports are defined on the
page. The
Sensor Installation
sensors and systems. To make sure that the information from the "most reliable" sensors
are used by the EK80, use the
The communication parameters defined for NMEA 0183 are:
•
: 4800 bit/s
Baud rate
•
: 8
Data bits
•
: Even
Parity
•
: 1
Stop bits
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3
On the left side of the
a
Select the relevant sensor in the
b
Make sure that the correct installation parameters are used for the sensor.
4
On the left side of the
a
Select the relevant sensor in the
b
Make sure that the correct parameters are used for sensor configuration.
5
Close the
Installation
6
Observe the top bar.
7
Make sure that the information from the sensor is displayed.
40
page allows your EK80 to communicate with external
Sensor Configuration
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box, select
Installation
dialog box without making any changes.
page to define a datagram priorities.
.
Sensor Installation
list.
Installed Sensors
Sensor Configuration
list.
Sensor
I/O Setup
.
.
401925/C
Advertisement
Table of Contents
