Table of Contents
Advertisement
•
: This channel is vacant and ready for use.
Available
Note
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3
On the left side of the
4
Install the channels(s).
a
Observe that the transceiver(s) you have connected to the Processor Unit are
listed.
Each transceiver is identified with type and serial number. The available
channels on each transceiver are listed separately.
Tip
If no transceivers are listed:
1
Select
Address
2
Select the correct address for the Ethernet adapter you are using.
Select
This will make the EK80 search the network for available transceivers.
3
Check that each transceiver has been turned on.
4
Verify that the Ethernet communication between the units is operational.
5
If you are using an Ethernet switch, make sure that it works.
6
If you have changed the network settings, turn each transceiver off and on.
EK80 automatically assigns an IP address to each transceiver when the
transceiver is turned off and on.
401925/C
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
in the
Browse
Transceiver Browsing
box.
.
Apply
.
Transceiver
box, and open the
Secondary procedures
to save the
Apply
.
Local IP
65
Advertisement
Table of Contents
