Cabling For Audio Signals; Analog Stereo - Genelec GLM 4 System Operating Manual

Loudspeaker manager glm

Hide thumbs Also See for GLM 4:

Table of Contents

Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual

page 10 of 87

Figure 1. Place monitors symmetrically relative to the walls. Point the acoustical axes towards the

listening position.

4.2 Cabling for Audio Signals

Run all audio cables from the audio source to the monitors. When a subwoofer is used, run the

same signal to the monitor and the subwoofer. We recommend running the signal to the subwoofer

first. The subwoofer has output connectors to facilitate onward connection to the monitors.

Bass management means using a subwoofer to reproduce low frequencies for any or all of the

audio channels. Audio channels for monitors that are not bass managed can be run directly to the

monitors. They do not need to run to the subwoofer.

When you need both analog and digital audio cabling, it is possible to populate both analog and

digital inputs and outputs on SAM monitors and subwoofers. GLM allows the Group configuration

to select either the analog or digital audio. Note that the 8320 monitor features an analog input

only.

The most common audio cablings are introduced next.

Before cabling, turn off the power in all monitors.



connect audio cables from the audio source to the monitor ANALOG IN

Table of Contents