Creating A Sam Monitor Group - Genelec GLM 4 System Operating Manual

Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual

5.2 Creating a SAM Monitor Group

A group preset is a set of monitors and subwoofers that reproduce audio together. A group preset
contains input and acoustic settings to optimize all monitors and subwoofers active within the
group. More group presets can be created to full fill any need e.g. calibrate system to the another
listening position.
To define a monitoring group:
1. Give the group a name that describes it (e.g. Analog Stereo)
2. Optionally you can set the System delay. It will be applied to all monitors and subwoofers in
the group.
3. Select and check the used bass management crossover frequency. This setting can be a
global when all monitors will follow the crossover selection from the crossover selection
below. If the setting is an individual, then crossover selections will be done individually for
each monitor via a settings popup
4. Select the Input mode (Digital channel can be changed from the Settings popup by clicking
a monitor icon).
5. Settings popup will popup when the monitor icon is clicked.
6. Name the monitor.
7. Make a monitor active or inactive within the group (in active monitor are indicated by
drawing light gray).
8. Select an input to be used.
9. Light icon indicates inactive within the group state (inactive monitors will be hidden in other
pages).
10. Normal icon indicates active within the group state.
11. Confirm the group settings by clicking on the 'Confirm Group' button.
For more detailed information on using and setting up Groups, see the section 'GLM Advanced
Use'.
page 30 of 87