Multipoint Calibration - Genelec GLM 4 System Operating Manual

Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual

7.15.1 MultiPoint calibration

GLM supports unlimited number of microphone positions in the 'MultiPoint' mode.
The steps of a MultiPoint calibration are

select 'MultiPoint' in the AutoCal window (additional microphone positions can be measured
after the primary position)

place the microphone in the primary listening position

press the 'Start Calibration' button to start the measurement and follow the dialogue
instructions – keep on selecting new measurement positions as long as needed, following
the dialogue instructions

wait until all the measurement sweeps have been completed for all monitors and
subwoofers, the press the 'Optimize' button to start the calculation process and wait until
completed

review the results by clicking on the monitor and subwoofer icons

continue to AutoPhase when there is a subwoofer in the system – before running the
AutoPhase, move the microphone to the primary (first) microphone position and follow the
dialogue instructions

continue to WooferCal when there is a W371 woofer in the system – before running the
AutoPhase, move the microphone to the primary (first) microphone position and follow the
dialogue instructions

accept the calibration result with the 'Confirm Calibration' button
Figure 32. Selecting the MultiPoint calibration
page 59 of 87