Maintenance and care
6.1.5
V-belt tension
Check the V-belt tension from time to time and retighten if it is loose.
•
Loosen all three fixing screws (1) on the motor.
•
Loosen lock nut (4)
•
Tighten the V-belt (3) via the set screw (2)
•
Retighten the fixing screws (1) on the motor and the lock nut (4).
The chain tension and V-belt tension should always be adjusted synchronously!
<
6.2
Repairs
Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by an expert.
Proceed as follows to move the handle from the transport
position to the working position:
•
Pull out one of the two spring latches (1) and turn it.
•
Pull out the other spring bolt (1) as well and at the same
time fold up the operating handle and let the spring bolt re-
engage (see figure).
•
Turn opposite spring bolt again and let it snap in.
51700008
Picture 5
V1
14 / 16
GB