Avaya 6424D+M User Manual page 42

CHAPTER 4. OPERATING PROCEDURES
Attendant Trunk-to-Trunk Connection
You can connect one outside number to another outside number by connecting two outgoing
trunks. The Privacy feature, if available, is automatically disabled so you can monitor calls
for disconnect. A warning tone is applied to the trunk to alert the talking parties before you
can monitor the call. The tone (1/2 second duration) is heard by all parties every 15 seconds
while you remain on the connection.
To originate a call:
1. Press an idle loop button.
ATND light goes on. PA light goes off.
If Call Detail Recording and Reporting (CDRR) is assigned and calls are to be
2.
charged to an account number, do Steps 3 and 4; if CDRR is not assigned, go to
Step 5.
Press .
3.
[START]
Listen for dial tone.
4. Dial CDRR account number access code and Account Charge Number.
Listen for dial tone.
If the call is to be placed on a private network and Automatic Alternate Routing
5.
(AAR)/Automatic Route Selection (ARS) feature is active, do Step 6 to connect a
trunk; if AAR/ARS is not active, go to Step 7.
Press , and dial AAR/ARS access code.
6.
[START]
Listen for dial tone.
7. If you use direct trunk group selection to select trunks, do Step 8. If you do not use
direct trunk group selection, go to Step 9.
Press direct trunk group select button.
8.
Listen for dial tone. ANS light goes on. Go to Step 10.
Press , and dial Trunk Group access code.
9.
[START]
Listen for dial tone. ANS light goes on.
4-20