Installation Safety Instructions; Use Only For Intended Applications - Intel SC5000 Subassembly Product Manual

Installation Safety Instructions

CAUTION
Integration of this assembly shall be done only by technically qualified
personnel.
Follow these guidelines to meet and maintain safety and product regulatory
requirements when integrating this Hudson chassis subassembly.
Read and adhere to all of these instructions and the instructions supplied
with this assembly. If you do not follow these instructions, the UL listing
will be void, and the product will most likely be non-compliant with other
regional product laws and regulations.

Use Only for Intended Applications

This product was evaluated as Information Technology Equipment (ITE) that may be installed in
offices, homes, schools, computer rooms and similar locations. The suitability of this product for
other Product Categories and Environments other than ITE applications, (such as medical,
industrial, alarm systems, and test equipment) may require further evaluation.
When you integrate this subassembly, observe all warnings and cautions in the Installation Guide.
To avoid injury, be careful of:
•
Sharp pins on connectors
•
Sharp pins on printed circuit assemblies
•
Rough edges and sharp corners on the chassis
•
Hot components (like processors, voltage regulators, and heat sinks)
•
Damage to wires that could cause a short circuit
WARNING
Do not open the power supply. Risk of electric shock and burns from
high voltage and rapid overheating. Refer servicing of the power supply
to qualified technical personnel.
To maintain the UL listing and compliance to other regulatory certifications and/or declarations,
the following regulated components must be used, and conditions adhered to. Information for
configurations can be found on Intel's Server Builder Website at
http://channel.intel.com/go/serverbuilder. If you do not have access to Intel's web address please
contact your local Intel representative.
•
SC5000 chassis (chassis is provided with power supply and fans)UL listed.
•
Server boardyou must use the Intel
•
Add-in boardsmust have a printed wiring board flammability rating of minimum UL94V-1.
Add-in boards containing external power connectors and/or lithium batteries must be UL
Recognized or UL Listed. Add-in boards containing modem telecommunication circuitry must
be UL Listed.
60
®
S840HM2 Server Board.
Intel SC5000 Server Chassis Subassembly Product Guide