Chapter 18
To Enable:
To Disable:
Name
router-id
18-26
ip ospf router-id
Command Mode: Interface
Description
To set the router-id for the system, use the ip ospf router-id
command. Use the no form of this command, to Revert to the
system default (the lowest IP address configured on the system).
* Note: OSPF must be disabled for this command to take effect.
If OSPF is enable on the system the change will not take
effect until OSPF is stopped and started again.
Command Syntax
ip ospf router-id <router-id>
[no] ip ospf router-id <router-id>
Table 18-19. Parameters, Keywords, Arguments
Definition
IP address that represents the router-id for the system.
Cajun P550R/P880/P882 Command Reference Guide