Table of Contents
Advertisement
10 Firmware Update Procedure
10.1 Configuration Setup
Configuration of the SkyEcho is accomplished by logging on to the device
directly from a computer or mobile device using the SkyEcho internal Wi-Fi
hotspot. No additional application is necessary.
The following are procedures for updating the SkyEcho firmware. You may
be provided with one or two files to update, corresponding to the
procedures below. The most recent firmware is always posted at
www.uavionix.com/support.
•
Save the provided firmware file(s) to an accessible location on your
computer prior to joining the SkyEcho Wi-Fi hotspot.
10.1.1 Connecting to the SkyEcho via Wi-Fi
1. To connect to the SkyEcho, power on SkyEcho and join a device to the
wireless network SSID named SKYECHO-XXXX using the procedure for
your device. This procedure is identical to joining any other public or
private Wi-Fi on your chosen device.
2. If required, enter
uavionix
as the WPA password for the secure Wi-Fi
network, then tap join. Note:
The No Internet Connection
message is
normal when connected to SkyEcho.
3. Open any browser on your computer/mobile device that is connected to
your SkyEcho via the Wi-Fi link and type in 192.168.4.1
The following landing page should load:
This page will show the SkyEcho status.
UAV-1002156-001
ECCN 7A994
Page
31 | 37
REV I
Advertisement
Table of Contents
